IRMGR41518 Experimental Methods (Spring 2023)

The course is connected to the following study programs

Master in Green Energy Technology (Compulsory in Materials for Energy Technology profile).

Lecture Semester

Second semester (spring).

The student's learning outcomes after completing the course

Knowledge:

The student

• has advanced knowledge of two experimental methods within energy technology

• can analyze experimental limitations and possible artefacts.

 

Skills:

The student

• can utilize two experimental methods for research and development in an independent manner

• can critically analyze data obtained by two experimental research methods.

 

General competence:

The student can solve problems related to experimental work.

Content

The students will learn how to use two different experimental research techniques, and how to critically analyze and interpret the data obtained with these techniques. The experimental techniques should be relevant for the student's planned Master Thesis. The course is module-based, where each module teaches one experimental technique. The student should select two relevant modules for the course.

 

The course is research based, and each student should therefore conduct measurements that results in new knowledge of the measured systems. The students should preferably conduct measurements on samples that are relevant for their planned master project, e.g., a small pre-study. The project reports should include a discussion regarding analysis and interpretation of the data (including relevant references to scientific research literature), and a discussion of possible errors and artefacts of both the measurements and interpretations.

 

Examples of available modules:

• Rheology - Viscoelastic properties of liquids and gels

• Dynamic light scattering and electrophoretic mobility - Determining hydrodynamic radius and zeta potentials

• Isothermal calorimetry - Heat flow rate of a sample due to chemical or physical changes in the sample

• Diffusive wave spectroscopy - Microrheology and size determination of turdid samples

• Compressive and flexural strength determination

• Electrospraying/Electrospinning- Producing nano particles and nano fibers

• Mechanical properties of materials

• 3D printing of construction materials

Forms of teaching and learning

The teaching will be a combination of supervision and screencasts.

Workload

125-150 hours.

Coursework requirements - conditions for taking the exam

• At least 85% attendance for lectures/lab classes

• Laboratory assignments according to the two chosen modules.

Examination

This exam concists of two parts:

Part 1: Project report from chosen module number 1. 50% of the evaluation

Part 2: Project report from chosen module number 2. 50% of the evaluation

The students will receive one final grade for the course as a whole.

Grades from A to F, where A is the best grade, E is the lowest passed grade, and F is failed.

Examiners

Two internal examiners.

Conditions for resit/rescheduled exams

If a project report is graded as failed, the students will be given one more chance to improve this report. A re-take will be arranged in August the following semester.

Course evaluation

The course will be evaluated by a standardized electronic form.

Literature

The current reading list for 2023 Spring can be found in Leganto